Nouveautés & Corrections
- Many causes of crashes have been eliminated.
- Eliminated DWG issues in libdxfrw, which caused several crashes.
- The performance of panning and zooming in large files has been significantly improved.
- The undo/redo engine has been completely revised due to several problems.
- Adjustments for new compiler and Qt versions were required.
- Extension of the command line, multi-line commands, paste and open command files.
- Improvement of the print preview, with tiled printing and line widths adjustment.
- Multiple selection and bulk actions in block and layer lists.
- Draft mode was not set for new/opened drawings.
- Performance did not improve when zooming into an area.
- Certain polylines were not rendered properly.
- Opening a file did't restore the layer's construction state.
- The cursor was hidden for 'polyline from existing'.
- Closing an inactive tab cleared the layer list.
- Wouldn't build with Qt4.
- Added non-uniform knots support.
- Added Edit -> Device Options.
- Eliminated crash on save when auto backup is off.
- Eliminated invalid bounding boxes from auto zoom.
- Fixed a few crashes due to undo and deleted entities.
- Rallaz fixed quite many issues in dxf and DWG support.
- If you are using spline/splinepoints, you may find some improvement in 2.0.9, as spline mirroring is fixed, and there is some cleanup for spline property editors, thanks to jaise for identifying this bug.
- If you use the feature "Draw -> Line -> Rectangle", please note a polyline is drawn instead of 4 separate lines.
- DWG read support!
- SVG export support!
(0 votes)
