-
Nouveautés et corrections du logiciel FotoSketcher 4.0.
- BugFixed : A bug related to the default printer could prevent FotoSketcher from running.
- BugFixed : The manual brush would not work properly when the custom frame was applied with "autofit" on.
- BugFixed : The program would sometimes freeze when going to the fotosketcher.com website from the "About FotoSketcher" window.
- BugFixed : Xarious small speed and stability enhancements.
- New Pencil Sketch 5 effect (replaces the previous one).
- New Light style for improved legibility.
- Possibility to run FotoSketcher in silent mode (via the command line interface or by editing a shortcut to pass parameters). The syntax is as follows :
- FotoSketcher.exe -silent Source.jpg Dest.jpg 18 80 180 40 50 255 n y n
- Where Source.jpg and Dest.jpg are respectively the filenames for the source image and the processd image, followed by the effect number (1 is Pencil Sketch 1, 2 is Pencil Sketch 2, etc...), followed by the 5 parameter values, and finally n/y for soften edges, frame and texture.
- For advanced users, this could be used to pilot FotoSketcher from another graphics program.
- The standard custom frame has been updated and will adapt better (less distortion) to the image ratio (square, portrait or landscape).
- Right-clicking on the small custom frame pictogram in the top-right corner reverts the custom frame to the default one if you had loaded another.
- The script engine (press F5 to open the Window) now has a default script built-in. Just click the Run button to test it or the trash can to clear the script.
(0 votes)
